Publicidad
Idiomas disponibles
Idiomas disponibles
Install your outdoor weather station on a suitable location minding the wind direction markings. Connect the anemometer to
the wind vane phone jacket. Connect the wind vane to the thermo-hygrometer WIND phone jacket. Connect the rain sensor
to the thermo-hygrometer RAIN phone jacket. Finally, insert 3 x AA batteries into the weather station respecting the polarity.
Insert 2 x AA batteries into the receiver respecting the polarity. Wait for the two stations to synchronize. This synchronisation
may take a couple of minutes. Do not touch the screen during synchronisation. Once the synchronisation finished, make sure
that all components work properly. Choose a suitable mounting location for the receiver. Commonly, the communication
between the two stations can reach a distance of 100m in the open field, provided that there are no obstacles such as
buildings, trees, vehicles, high-voltage lines, etc. Radio interference such as from PCs, radios and television sets can entirely
cut off the communication. Take this into consideration when choosing a mounting location.
3. The Different Functions
• Indoor Temperature
o Touch the indoor temperature section once and press + or – to switch
between the temperature display in °C or °F.
o Touch the indoor temperature section a second time and press + or – to set
the high temperature alarm (HI AL), or press ON/OFF to switch the alarm
on or off.
o Touch the indoor temperature section a third time and press + or – to set
the low temperature alarm (LO AL), or press ON/OFF to switch the alarm on
or off.
o Touch the indoor temperature section a fourth time to display the maximum
temperature reading. Hold the value pressed to reset the value.
o Touch the indoor temperature section a fifth time to display the minimum
temperature reading. Hold the value pressed to reset the value.
WS1080_v8
4
VELLEMAN
Publicidad
