Publicidad
Idiomas disponibles
Idiomas disponibles
1. Identify the two back feet
a threaded screw on one of their outer faces.
2. Fix on each of the four supplied feet a wheel with brake
screw on each foot.
S
BACK FOOT (B)
3. Attach two connecting plates
DIN 125 M6
washers and two DIN 7380 M6X12
T
BACK FOOT (B)
4. Place the main structure
the two front feet
C
washers and two DIN 7380 M6X12
T
The feet have to be mounted in the position shown in the following image.
The two front feet
26
and the two front feet
B
to each of the four feet, as shown in the following images. To do this, use two
D
on the ground as shown in the following image. Assemble the two back feet
A
on it, following the indications. Finally, fix each of them to the structure using two DIN 125 M6
screws.
U
must be oriented with the screw towards the outside of the equipment.
C
www.masterproducts.es
. These last two differ from the first two because they have
C
. Use a DIN 125 M12
P
screws on each foot.
U
¡IMPORTANT!
washer and a DIN 933 M12x30
R
FRONT FOOT (C)
FRONT FOOT (C)
and
B
Publicidad
