Publicidad
Idiomas disponibles
Idiomas disponibles
10. dentify the four supplied sorting grids and place them on top of the double deflectos in the order shown in the
following image.
¡IMPORTANT!
The sorting grids must be placed in the order indicated in the following image.
The 30mm sizing grid is closest to the front two feet
.
C
The circle in the image shows the screw for one of the two front feet
.
C
c
c
11. Fix the two braces
to the front base
as shown in the following image. Use a DIN 985 M6 nut
and two
V
O
N
DIN 125 M6 Nylon washersand and two DIN 125 M6 Nylon washers
for each brace. Follow the assembly order
W
shown, placing a Nylon washer on each side of the brace.
12. Fix the front base assembly to the two front feet
of the main structure
as shown in the following image.
A
C
First, place a DIN125 M10 Nylon washer
between the outer face of each front foot
and the inner face of the
X
C
front base assembly, at the level of the ears. Then screwing a DIN 912 M6x20
screw into each ea. Secondly, turn
Y
the two braces and fit the hole of each brace into the screw of the two front feet
.
C
30
www.masterproducts.es
Publicidad
