Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
APPLICATIONS
You may use this product for the following purpose:
Charging RYOBI USB Lithium batteries
CAUTION:
If charge does not appear to initiate or appears to stop
charging the battery pack before reaching full charge,
check that charger is properly plugged into a power
supply (outlet) and that the power supply is energized. If
so, try charging a different battery pack. If the different
battery pack charges properly, then return the battery
pack that did not charge properly. If a different battery
pack does not charge, return the charger and the battery
pack(s). Make returns to the nearest authorized service
center for service or replacement.
NOTICE:
Charge in a well-ventilated area. Do not block charger
vents. Keep them clear to allow proper ventilation.
KEYHOLE HANGER
See Figure 1, page 7.
To mount the charger, only use the key hole hanging feature.
Screws should be installed so that the center distance is
1-1/2 in.
ASSEMBLY
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
OPERATION
CHARGING
See Figures 2 - 3, page 7.
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
them before first use. If the charger does not charge your
battery pack under normal circumstances, return both the
battery pack and charger to your nearest repair center for
electrical check.
Charge time varies and is dependent upon the amp hour
capacity and charge level of the battery pack(s).
NOTE: Charger charges batteries one at a time; charger does
NOT charge multiple batteries simultaneously.
Make sure the power supply is normal household voltage,
120 volts, AC only, 60 Hz.
Connect the charger to a power supply.
Insert the battery pack into the charger. Make sure the
raised rib on the battery pack aligns with the groove in
the charger.
Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
NOTE: Batteries are charged in sequence. When a sec-
ond or third battery is added, their light will glow solid
red. Once the first battery is finished charging, the next
battery will flash green and its charging cycle will begin.
Do not place the charger in an area of extreme heat or
cold. It will work best at normal room temperature.
The battery pack may become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
When the battery pack is charging, the green LED will
begin to flash.
After the battery is fully charged, the green LED will remain
on while the charger is in Energy Save Mode.
When the battery pack is fully charged, remove it from
the charger.
4 — English
Publicidad
