ASROCK 939NF6G-VSTA Manual Del Usuario página 13

2.4 Easy Multi Monitor Feature 2.4 Easy Multi Monitor Feature 2.4 Easy Multi Monitor Feature
2.4 Easy Multi Monitor Feature 2.4 Easy Multi Monitor Feature
This motherboard supports Multi Monitor upgrade. With the internal onboard VGA
and the external add-on PCI Express VGA card, you can easily enjoy the benefits
of Multi Monitor feature. Please refer to the following steps to set up a multi
monitor environment:
®
1. Install the NVIDIA PCI Express VGA card to PCIE1 (PCIE x16 slot). Please refer
to page 12 for proper expansion card installation procedures for details.
2. Connect the D-Sub input monitor cable to the VGA/D-Sub port on the I/O panel
of this motherboard. Connect another D-Sub input monitor cable to the
VGA/D-Sub connector of the add-on PCI Express VGA card. Connect the DVI-D
input monitor cable to the VGA/DVI-D connector of the add-on PCI Express VGA
card.
3. Boot your system. Press <F2> to enter BIOS setup. Enter "Share Memory"
option to adjust the memory capability to [16MB], [32MB], [64MB], [128MB], or
[256MB] to enable the function of onboard VGA/D-sub. Please make sure that
the value you select is less than the total capability of the system memory. If
you do not adjust the BIOS setup, the default value of "Share Memory", [Auto],
will disable onboard VGA/D-Sub function when the add-on VGA card is
inserted to this motherboard.
4. Install the onboard VGA driver to your system. If you have installed the
onboard VGA driver already, there is no need to install it again.
5. Set up a multi-monitor display. Right click the desktop, choose "Properties", and
select the "Settings" tab so that you can adjust the parameters of the multi-
monitor according to the steps below. (The item names and operation
procedures described in this step are under Windows
®
install other Windows OS, the item names and operation procedures may be
similar.)
A. Click the "Identify" button to display a large number on each monitor.
B. Right-click the display icon in the Display Properties dialog that you wish to
be your primary monitor, and then select "Primary". When you use multiple
monitors with your card, one monitor will always be Primary, and all
additional monitors will be designated as Secondary.
C. Select the display icon identified by the number 2.
D. Click "Extend my Windows desktop onto this monitor".
E. Right-click the display icon and select "Attached", if necessary.
F. Set the "Screen Resolution" and "Color Quality" as appropriate for the
second monitor. Click "Apply" or "OK" to apply these new values.
G. Repeat steps C through E for the diaplay icon identified by the number one,
two, and three.
ASRock
®
939NF6G-VSTA Motherboard
XP environment. If you
1 3 1 3 1 3
1 3 1 3