Publicidad
Idiomas disponibles
Idiomas disponibles
2.8 Serial A
2.8 Serial AT T T T T A (SA
2.8 Serial A
A (SA
A (SA
A (SAT T T T T A) / Serial A
2.8 Serial A
2.8 Serial A
A (SA
Installation
Installation
Installation
Installation
Installation
This motherboard adopts NVIDIA
/ nForce 430 chipset that supports Serial ATA (SATA) / Serial ATAII (SATAII) hard
disks and RAID functions. You may install SATA / SATAII hard disks on this
motherboard for internal storage devices. This section will guide you to install the
SATA / SATAII hard disks.
STEP 1: Install the SATA / SATAII hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA / SATAII hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard's SATAII
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA / SATAII hard
disk.
2.9
2.9
2.9
2.9
2.9
Hot Plug and Hot Swap Functions for SA
Hot Plug and Hot Swap F
Hot Plug and Hot Swap F
Hot Plug and Hot Swap F
Hot Plug and Hot Swap F
HDDs
HDDs
HDDs
HDDs
HDDs
This motherboard supports Hot Plug and Hot Swap functions for SATA / SATAII
Devices.
NOTE
What is Hot Plug Function?
If the SATA / SATAII HDDs are NOT set for RAID configuration, it is
called "Hot Plug" for the action to insert and remove the SATA / SATAII
HDDs while the system is still power-on and in working condition.
However, please note that it cannot perform Hot Plug if the OS has
been installed into the SATA / SATAII HDD.
What is Hot Swap Function?
If SATA / SATAII HDDs are built as RAID1 or RAID 5 then it is called
"Hot Swap" for the action to insert and remove the SATA / SATAII
HDDs while the system is still power-on and in working condition.
2.10
2.10
2.10
2.10
2.10 Driver Installation Guide
Driver Installation Guide
Driver Installation Guide
Driver Installation Guide
Driver Installation Guide
To install the drivers to your system, please insert the support CD to your optical
drive first. Then, the drivers compatible to your system can be auto-detected and
listed on the support CD driver page. Please follow the order from up to bottom
side to install those required drivers. Therefore, the drivers you install can work
properly.
2 0
2 0
2 0
2 0
2 0
ASRock
A) / Serial AT T T T T AII (SA
A) / Serial A
A) / Serial A
AII (SAT T T T T AII) Hard Disks
AII (SA
AII (SA
A) / Serial A
AII (SA
®
GeForce 6100 / nForce 430 or GeForce 6150SE
unctions for SAT T T T T A / SA
unctions for SA
unctions for SA
unctions for SA
939NF6G-VSTA
Motherboard
AII) Hard Disks
AII) Hard Disks
AII) Hard Disks
AII) Hard Disks
A / SA
A / SA
A / SAT T T T T AII
A / SA
AII
AII
AII
AII
Publicidad
