Publicidad
2.0
Fuse
Fuse
5A
15A
Relé
Gas Pressure
Temperature
Gas
Inlet
LPG EV
WARNING:
- Follow carefully petrol and gas injectors sequence as shown in the diagram.
- Never connect front and back Solenoid Valve cables to the Ground.
- In order to make a front and back Solenoid Valve right diagnostic, don't connect them to each other.
- Never replace fuses with another ones with bigger amperage.
CAUTION:
Be careful with the cars for which the manufacturer prohibits or advises against disconnecting the battery, not to alter the antitheft devices or automatic adaptivity -
Never use welders connected to the battery of the same car - Connect with suitably insulated soft solderings - Position the BRC electrical devices in a well ventilated
area, protected from water seepages and heat sources - We recommend to insulate the BRC electronic control unit wires which are not connected - BRC reserves the
right to modify this diagram without notice - We also recommend you to be sure to have the last revision of the diagram drawn up by BRC.
M.T.M. Srl
SEQUENT DIRECT INJECTION 2.0
Suzuki Vitara 1.4 Boosterjet 4WD 16V 103kW K14C EURO 6Dtemp GPL
Multipoint Electronic Injection
Changeover Switch
Cut and
Insulate
Singularly
and
Sensor
Gas Injectors Sequence
Wiring diagram
Diagnostic
Point
Red
3
2
1
Black
Black
Black
Red
Red
Cut and
Insulate
Singularly
Pin n° 92 Conn. E01 - 94 Pin
Pin n° 61 Conn. E01 - 94 Pin
Pin n° 83 Conn. E01 - 94 Pin
Pin n° 50 Conn. C01 - 60 Pin
Pin n° 22 Conn. C01 - 60 Pin
Pin n° 32 Conn. C01 - 60 Pin (1° Injector Signal)
Pin n° 33 Conn. C01 - 60 Pin (1° Injector Positive)
Pin n° 1 Conn. C01 - 60 Pin (2° Injector Signal)
Pin n° 16 Conn. C01 - 60 Pin (2° Injector Positive)
Pin n° 46 Conn. C01 - 60 Pin (3° Injector Signal)
Pin n° 31 Conn. C01 - 60 Pin (3° Injector Positive)
Pin n° 47 Conn. C01 - 60 - Pin (4° Injector Signal)
Pin n° 48 Conn. C01 - 60 Pin (4° Injector Positive)
Sensor
temperature
water
DO NOT CONNECT
Petrol
Injectors
Sequence
10|10
Date:
Diagram n°:
In place of diagran n°:
Draftsman.:
Signature:
Level sensor connector
Cut and Insulate
Rear Solenoid Valve Connector
+
-
Battery
Warning: CAN BUS connection
can NOT be made on diagnostic
socket level, but it MUST be made
on petrol ECU connector level.
Petrol
ECU
Pin n° 40
Conn. C01 - 60 Pin
White (MAP)
Map sensor
DO NOT CONNECT
20_12_18
-
//.//.//
I.C.
fusibili
MV
FSG000105R-1
Publicidad
