Publicidad
Enlaces rápidos
M.T.M. Srl | Società Unipersonale
Via La Morra, 1 | 12062 Cherasco (Cn) | Italy
Tel. +39 0172 4860140 | Fax +39 0172 593113
info@brc.it | www.brc.it
Codice istruzione
Instruction code
Code d'instruction
Código instrucción
Versione
Version
Version
Versión
Codice kit
Kit code
Code kit
Código kit
Sistema
Costruttore
Builder
Constructeur
Constructor
Modello
Model
Modèle
Modelo
Cilindrata
Cubic capacity
Cylindrée
Cilindrada
Sigla motore
Engine type
Type de moteur
Código del motor
Petrol ECU
EURO
Cambio
Transmission
Transmission
Transmisión
FSG000083R
n° 1 - 02/03/2017
09SQ4SDIPM84
SEQUENT DIRECT INJECTION 2.0
Mazda
CX5 Skyactive
2.0 cc - 16 V - 118 kW
PE
MITSUBISHI
5B
Automatico
Automatic
Automatique
Automático
Lpg
Publicidad
Manuales relacionados para BRC 09SQ4SDIPM84
Resumen de contenidos para BRC 09SQ4SDIPM84
- Página 1 M.T.M. Srl | Società Unipersonale Via La Morra, 1 | 12062 Cherasco (Cn) | Italy Tel. +39 0172 4860140 | Fax +39 0172 593113 info@brc.it | www.brc.it Codice istruzione Instruction code FSG000083R Code d’instruction Código instrucción Versione Version n° 1 - 02/03/2017 Version Versión...
- Página 2 Veuillez respecter les instructions suivantes pendant l’installation du système gaz: • Merci de vérifier sur notre site internet WWW.BRC.IT (“Espace Réservé”) la version et la date de cet instruction! • C’est la responsabilité du mécanicien de vérifier et respecter les normes nationales pour réaliser toutes modifica- tions nécessaires pour le montage.
- Página 3 - Eseguire i collegamenti con saldature a stagno opportunamente isolate - Posizionare i dispositivi elettrici BRC in zona ben ventilata, al riparo da infiltrazioni d'acqua e da fonti di calore - Si raccomanda di isolare i fili della centralina BRC che non vengono collegati - BRC si riserva di modificare il presente schema senza alcun preavviso - Si consiglia di verificare di essere in possesso dell'ultima revisione di schema redatta dalla BRC.
- Página 4 Be careful with the cars for which the manufacturer prohibits or advises against disconnecting the battery, not to alter the antitheft devices or automatic adaptivity - Never use welders connected to the battery of the same car - Connect with suitably insulated soft solderings - Position the BRC electrical devices in a well ventilated area, protected from water seepages and heat sources - We recommend to insulate the BRC electronic control unit wires which are not connected - BRC reserves the right to modify this diagram without notice - We also recommend you to be sure to have the last revision of the diagram drawn up by BRC.