Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION AND ADJUSTMENT
The two markings (8) of the saw line can be used when the saw blade is set to 0 and 45
degrees respectively.
Adjusting the parallel guide
Adjust the parallel guide (16) to the desired
distance from the blade (9) and tighten the
wing screw (7).
Setting the bevel angle
Release the baseplate angle adjustment knob
(6) on the front of the saw, and rotate the upper
part of the saw to the desired angle (0-45° from
vertical). The angle can be read off the angle
gauge (5). Retighten the bevel adjustment
knob.
Adjusting the cutting depth
The cutting depth can be adjusted by loosening the
depth adjustment screw (15) and angling the upper
part of the circular saw until the blade is at the desired
cutting depth relative to the baseplate.
Re-tighten the depth adjustment knob. The cutting
depth can be read off from the depth gauge (14) and
this must be at least 3 mm more than the thickness of
the workpiece.
Note: The cutting depth cannot be reduced if the
saw is set up for bevelling!
Connecting dust extractor
If necessary, attach a vacuum hose or a dust collector
hose to the nozzle outlet (1).
28
Publicidad
