Publicidad
Idiomas disponibles
Idiomas disponibles
USE
saw to reach full speed before starting to cut.
Cut with the motor section of the saw on the
same side as the part of the workpiece that is not being sawn off .
Hold the saw by the handle (2) and support grip (4) and cut in a straight line.
The blade guard (12) opens automatically when the blade comes into contact with the work-
piece.
Do not try to force the saw to the side.
Release the on/off button immediately if the blade becomes stuck in the workpiece. If this
does happen, the saw can be thrown back violently towards the operator.
Check that the blade guard closes when the saw is lifted off the item.
REPLACING THE BLADE
Always secure the item to be worked with
clamps or similar. Never hold the item in place
by hand.
Adjust the bevel angle, parallel guide and cut-
ting depth if necessary (see Preparation and
Adjustment).
Check that the saw is correctly set up and that
all handles and screws are correctly tightened
before starting to saw.
Place the front of the baseplate on the work-
piece.
Press the safety switch (13) and depress the
on/ off button (3) on the handle (2). Allow the
Disconnect the saw from the mains. The blade
must be perpendicular to the baseplate.
Loosen the depth adjustment knob and lift up the
upper part of the saw as far as it will go.
Hold the spindle securely using the spanner (17)
so that it cannot turn round. Undo lock screw
(11) by turning it anti-clockwise using the Allen key
(18).
Remove the lock screw (11) and flange (10). Open
the blade guard (12) and lift off the blade.
29
Publicidad
