Powerworks P60PHT Manual Del Operario página 4

EN
1 DESCRIPTION
1.1 PURPOSE
This machine is intended for cutting and trimming
hedges and bushes in domestic use.
1.2 OVERVIEW
Figure 1
1 Blade
2 Pivoting head
3 Pivoting button
4 Coupler
5 Safety lock button
2 SAFETY
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3 UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
3.1 FIT THE PIVOTING HEAD
Figure 2
1. Align the handle with the trimmer head.
2. Push the trimmer head onto the handle.
3. Fasten the coupler.
Periodically check the connections to ensure that they
are tightened securely.
6 Trigger
7 Rear handle
8 Battery release
button
9 Auxiliary Handle
WARNING
WARNING
WARNING
WARNING
English
3.2 REMOVE THE PIVOTING HEAD
Figure 3
1. Rest the machine on the ground.
2. Loosen the coupler.
3. Take off the poviting head.
3.3 ATTACH THE AUXILIARY HANDLE
Figure 4.
1. Loosen the screws in the handle with a screwdriver
(not included) and remove the screws from the
handle.
2. Attach the auxiliary handle and clamp on the shaft.
3. If necessary, adjust handle up or down to desired
operating position.
4. Insert and tighten the screws so that the handle
cannot be rotated on the shaft.
3.4 INSTALL THE BATTERY PACK
Figure 5
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.5 REMOVE THE BATTERY PACK
Figure 5
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
• Touch the blade carefully.
• Do not put your fingers into the notches or in
position where they can get cut.
• Do not touch the blade unless you remove the
battery pack.
• Do not use the machine if the blade is damaged or
bent.
• Remove all objects such as cords, lights, wire, or
string which can become entangled in the cutting
blade and create a risk of personal injury.
4
WARNING