Denver Electronics MC-5220 MK2 Manual De Instrucciones página 7

HANDING A COMPACT DISC
• Always protect a disc against scratches, soil , dust and etc. If a disc is treated with reasonable
care, wiping off the disc with a soft cloth should be the only maintenance needed to retain its
excellent sound reproduction. Discs should be retained in their original case during periods
of non-use.
• Handle a disc only by its edges, Do not touch the surface or rainbow-colored side of the disc
• Handle a disc as shown in the illustrations in this section
• Use a soft cloth to wipe a disc clean. Do not use benzene, thinner, or other chemical cleaners
to clean the disc as damage may result. A disc should always be wiped in a straight line from
its center to its edge. Never wipe a disc in a circular motion.
• Do not expose a disc to direct sunlight, high humidity, or high temperatures for extended
periods of time. Do not place the Disc on other equipment or near any heat source.
• Dust on the pickup lens can lead to erratic operation and interruption of the sound during
play. To clean the pickup lens, open the disc compartment and blow the dust off . Using a
camera lens blower(available at most camera stores)
• Note: Do not touch the surface of the lens. Do not allow any liquids on the inside of the
product.
• To clean the CD player cabinet, use a soft and damp cloth to wire off the exterior surface.
• Never use benzol, benzene, or other strong chemical cleaners, as these could damage the
finish.
DO:
PLAYING A COMPACT DISC (CD)
NOTE: Never touch the laser lens inside of the CD compartment. Clean the laser lens with a CD
cleaner disc if it becomes dirty.
1. Press the Standby button to turn on the unit
2. Press the Function Switch to CD mode.
3. Open the CD DOOR and insert a CD into the tray with printed label side facing up.
4. Close the CD DOOR and the disc will rotate for a few seconds and then stop.
5. Use the or
6. Press the
7. Press the
8. To stop the album temporarily, press PAUSE button, to resume, press again
RANDOM PLAY
• In CD stop mode, Press the REPEAT button on the remote until "RAND" will appear on LCD
Display.
• Then it will enable random tracks play.
REPEAT FUNCTION
1. Press the MODE button on the remote once during playback, the "
LCD display. The same track will be repeated over and over.
2. Press the MODE button on the remote a second time to repeat all tracks. The "
sign will show on the LCD display.
3. To cancel REPEAT PLAY, Press the MODE button on the remote repeatedly until the all
sign disappeared.
button to choose a track
BUTTON to start play
BUTTON again to PAUSE play.
DO NOT:
ENG-7
" sign will show on
ALL"