Publicidad
Idiomas disponibles
Idiomas disponibles
Before performing cleaning, adjusting, repairing and
maintenance tasks, always unplug the power cord.
Replace worn out or damaged parts immediately, so that
the power tool is always in a safe operating condition.
Cleaning:
The power tool should be fully cleaned thoroughly after
use.
Do not use aggressive cleaning products. These products
may damage plastics and metals, compromising the safe
operation of the power tool.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out, all other works must be
performed by an official dealer.
If components or safety devices are removed for
maintenance purposes, they must be repositioned correctly
and immediately.
Maintenance of double insulated tools requires extreme
care and knowledge of the whole system and should only
be carried out by a qualified technician. Replacement of
components of a double insulated power tool should be
carried out with the same parts as the originals.
Use only VITO-approved accessories for this power tool or
technically identical parts. Failure to do so may result in
personal injuries or damages to the drywall vacuum
cleaner. If in doubt, if you lack knowledge or resources, you
should contact an official dealer.
Your drywall vacuum cleaner should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts.
Fixed wheels (13)
1. Fit the wheels on the vacuum cleaner base;
2. Place and tighten the bolts in the holes.
Caster wheels (1)
1. Insert the wheel fixing pin into the hole.
1. Insert the hose connector into the suction port (3);
2. Check that the hose is securely fastened.
To remove the suction hose:
1. Press the button and remove the hose.
1. Insert one of the tubes into the suction hose (8);
2. Insert the second suction tube (9) into the first;
3. Insert one of the suction accessories into the end of the
tube.
Publicidad
