VITO PRO POWER VIAG25 Manual De Instrucciones página 25

Do not run the vacuum cleaner for more than 4 hours,
including rest breaks. Make sure the vacuum cleaner is
regularly switched off to allow the motor to cool down
(every 15 min switch off for 1 min). Otherwise, you may
damage the motor.
Never use this machine for vacuuming:
▪ Hazardous dust to health;
▪ Hot or burning materials such as cigarettes, matches or
hot ashes;
▪ Flammable or combustible liquids, such as petrol,
solvents, acids or bleach;
▪ Combustible or explosive dusts, e.g. magnesium dust;
▪ Sharp objects.
Never use the vacuum cleaner if the suction power is too
low. If this happens check the cleanliness of the filters
(refer to the maintenance instructions). Also check if there
are any blockages or clogging in the hose, tube or suction
accessories.
Avoid vacuuming up debris and materials that could reduce
airflow and block or clog accessories.
Do not operate the vacuum cleaner if it does not function
normally. If the problem persists, have the vacuum cleaner
serviced by the brand technical assistance.
1. Unwind the power cord and plug it into the socket;
2. Attach the nozzle according to the waste to be
vacuumed;
3. Set the "ON/OFF" button (4) to the "I" position;
To switch off the vacuum cleaner:
4. Set the "ON/OFF" button to the "O" position and unplug
the power cord. Always switch off the vacuum cleaner
before unplugging the power cord;
5. Wind the power cord.
1. Set the "ON/OFF" button to the "
2. Attach the suction tube and plug the power tool into the
vacuum cleaner socket.
In the " " position, the vacuum cleaner switches on
automatically when you switch on the power tool.
In this mode the vacuum cleaner will run 2 to 8
seconds longer than the power tool.
1. Fit the dust and solids floor nozzle (14) and adjust its
position according to the type of floor to be vacuumed;
2. Keep all filters in place inside the vacuum cleaner.
1. Fit the dust and solids floor nozzle;
2. Keep all filters in place inside the vacuum cleaner.
" position;