Hunter La Strada Guia De Instalacion página 15

Existing Construction – accessible only from below
D11
EXISTING FAN
Remove an existing fan and check to make sure the open-
ing is large enough to accommodate the new motor hous-
D13
Route wires through strain relief
D15
Install the housing flush with the sheetrock and secure by
tightening the pre-loaded screws into the joist.
42949-01 04/18/2007
ing (8"x 8 1/2").
.
F
D12
Move the housing into position above the ceiling
D14
Attach existing ducting to duct connector. Tape joints.
If ducting does not fit securely,
an adapter may need to be purchased.
F
15