Publicidad
Idiomas disponibles
Idiomas disponibles
TO REDUCE THE RISK Of ELECTRIC SHOCK OR INJURY, OBSERVE THE fOLLOWING:
1. Use this unit only in a manner intended by the manu-
facturer. If you have questions, contact the manufac-
turer at the phone number or address listed in the
warranty.
2. Before installing, servicing, or cleaning the unit,
disconnect the power by turning off the circuit break-
ers to the outlet box and associated wall switch loca-
tion. If you cannot lock the circuit breakers in the off
position, securely attach a prominent warning device,
such as a tag, to the service panel.
3. Installation work and electrical wiring must be done
by qualified person(s) in accordance with all applicable
codes and standards, including fire-rated construction
codes and standards.
C A U T I O N
1. for general ventilating use only. Do not use for
ventilating hazardous or explosive materials.
2. To avoid motor bearing damage and noisy/unbal-
anced impellers, keep drywall spray, construction
dust, etc. off power unit.
3. DO NOT install this product in a wall. This prod-
uct is designed for installation in ceilings up to a
12/12 pitch (45 degrees). Ductwork must point
upward.
4. please read specification label on product for fur-
ther information and requirements.
pREVENTATIVE MAINTENANCE
A clean fan provides better service. Disconnect the power supply and clean the fan as listed below.
TO CLEAN GRILLE:
Use a mild detergent, such as dishwashing liquid, and a soft cloth. DO NOT use abrasive cloths, steel wool pads
or scouring powders.
TO CLEAN fAN ASSEMBLY: Unplug motor cord from receptacle. To remove motor plate, find the single tab on the
motor plate (located next to the receptacle). push up rear motor plate tab while pushing out on the side of the
housing or insert a screwdriver into the slot in the housing (next to tab) and twist screwdriver. Gently vacuum
fan, motor and interior of housing.
METAL AND ELECTRICAL pARTS SHOULD NEVER BE IMMERSED IN WATER.
MAINTENANCE
The motor is permanently lubricated and never needs oiling. If the motor bearings are making excessive or
unusual noises, replace the motor with the exact service motor. You should replace the impeller at the same
time.
2
W
A
R
N
4. When cutting or drilling into wall(s) or ceiling, do not
5. Ducted fans must always be vented to the outdoors.
6. Acceptable for use over a bathtub or shower when
7. Install fan at least 5 feet (1.52 m) above the floor.
8. Never place a switch where it can be reached from a
9. This unit must be grounded.
I
N
G
damage electrical wiring or other hidden utilities.
Keep ducting as short and as straight as possible.
connected to a GfCI protected branch circuit.
tub or shower.
W A R N I N G
DISCONNECT
ELECTRIC
pOWER SUppLY
AND LOCK OUT
SERVICE pANEL
BEfORE
SERVICING UNIT
42949-01 04/18/2007
Publicidad
