Publicidad
GB
LITHIUM-BOOSTER JUMP START DEVICE
Art.
Rated voltage / Clamp Output
Power supply / Clamp Output
Battery size
Input
Integrated battery pack
Type of protection
Jump leads
Storage temperature
Operating temperature
Dimensions L x W x H
Weight
Power supply unit
Car charging adapter
For Your Safety
Please read and comply with these operating instructions
prior to initial operation of your device. Keep these ope-
rating instructions for later use or for a subsequent owner.
owner.
Responsibilities of the operator
The operator agrees to only allow persons to work with
the device who are familiar with the basic regulations on
occupational safety and accident prevention and have been
instructed in the handling of the device.
Responsibilities of personnel
Before starting work, all persons working with the device
agree to comply with the basic regulations on occupational
safety and accident prevention. & to read these operating
instructions, especially the chapter "Safety Instructions".
Before leaving the workplace, make sure that there is no risk
of personal injury or damage to property in your absence.
Unauthorised alterations and modifications are
prohibited
Modification of the device or manufacturing of additional
devices is not permitted. Such modifications can result in
personal injury or malfunctions.
Only appointed and trained personnel may carry out repairs
to the device. Always use Würth original spare parts. This
will ensure the continuing safe operation of the device.
18
Technical Data
Peak
Cranking
General safety instructions
Prior to first use always read the safety instruc-
tions! Failure to observe the operating instructions and the
safety instructions could result in damage to the appliance
and danger for the operator and other persons.
All persons involved in the commissioning, operation, main-
tenance and upkeep of the device must be appropriately
qualified.
Keep these operating instructions for later use or for a sub-
sequent owner.
Use only genuine Würth accessories and spare
parts.
•
Before use, make sure that there is no damage to the
device.
•
Do not operate the device if the housing, cable or
charging clamps are damaged.
•
Do not open, alter or tamper with the device. The device
must only be opened by a Würth service technician.
•
The appliance must only be supplied at safety extra low
voltage corresponding to the marking on the appliance.
•
Only use the appliance in a well ventilated area. Ensure
adequate workplace ventilation.
•
Do not cover the device. Risk of overheating!
12V LI-ION
0772 150 004
12 V DC
2000 A
1000 A
89,6 Wh
15 V DC, 2A
LiFePO
4
IP66
800mm (4AWG)
with clamps
-10 °C ... +45 °C
-20 °C ... +60 °C
324.5 x 80.5 x 229.0 mm
3,31 kg
Charging time
4 h ... 5 h
5,5 h ... 6 h
Safety instructions
Publicidad
