Faucet Installation - GE Reverse Osmosis GXRM10GBL Manual Del Propietario Y Instalación

FAUCET INSTALLATION

Be sure there is room underneath the sink to
make the needed connections. Select one of
the following locations to install the faucet:
• In an existing sink spray attachment or soap
dispenser hole.
• In a hole to be drilled in the sink top.
• In a hole to be drilled in the countertop,
next to the sink.
NOTE: Be sure the faucet base will fit flat
against the surface at the selected location
so the gasket will seal.
1. If drilling is needed, make a 1-1/4" dia.
hole. Be sure to use the proper procedure
for drilling porcelain or stainless steel.
2. Insert the faucet spout into the body.
Tighten cap until snug.
3. Feed the blue, 1/4" black and 3/8" black
tubes up through the hole in the
countertop or sink.
4. Feed the two black tubes up through the
gasket, faucet base and O-ring.
Spout
Cap
Body
Mounting
disk
Nut
NOTE: For ease of service and maintenance,
keep tubing lengths long enough so removal
of the Reverse Osmosis system from under
the sink is possible.
Installation Instructions
ASSEMBLED
Handle
O-ring
Base
Gasket
Lock washer
Tubing adapter
5. Push the 1/4" black and 3/8" black tubing
onto their respective barb fittings on the
body.
6. Seat the base and body together. Make
sure the O-ring and gasket are in place
when the base meets the body. The faucet
handle will be at the 3 o'clock position
with respect to the base.
7. Slide the lock washer onto the threaded
stem of the body, then thread the brass
nut onto the stem. Screw about halfway up.
8. Screw the tubing adapter to the threaded
stem of the body.
9. Push the blue tubing into the adapter. It
should go in about 1/2". Pull on it to make
sure it is installed securely.
10. Feed the tubing and stem back down
through the 1-1/4" hole.
11. Under the counter, insert the mounting
disk above the lock washer and tighten
the brass nut until snug.
3/8" barb
fitting
Black 3/8"
tubing,
27" long
Black 1/4"
tubing
To drain
8
1/4" barb
fitting
Lock washer
Nut
Tubing adapter
Blue 3/8" tubing
From RO
From RO