Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Installation
Instructions
Your new GE icemaker water filter comes complete with all the necessary hardware for installation.
Each filter gives you up to six months of great-tasting water. Filter should be changed after 6 months of use.
Do not use where water is microbiologically unsafe
or of unknown quality without adequate disinfection
before or after the system.
WARNING
Small parts remaining after the installation could be
a choke hazard. Discard safely
• This System has been tested according to NSF/ANSI 42 for reduction of the substances listed below. The concentration of the indicated substances in water entering
the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42.
• Actual performance may vary with local water conditions.
Service
Service
Model
Flow rate
GXRTDR
0.5 gpm
2500 gal. (9463 liters)
(1.9 lpm)
or 6 months
Testing parameters: Influent Challenges = pH 7.5 ± 0.5; Temperature 68°F ± 5°F (20°C ± 3°C); Pressure 60 psig; Flow Rate = 0.5 gpm
If slow water or hollow ice occurs, replace filter.
• Protect from freezing. Drain filter when room temperature is expected to drop below 32°F (0°C).
• Use the in-line water filtering system on a potable, safe-to-drink, home COLD water supply only.
The filter will not make unsafe water safe to drink. Do NOT use on HOT water (100°F max).
• Do not install on line pressure above 125 psi (862 kPa) or below 25 psi (172 kPa).
• All of the refrigerator installation requirements must be met when installing the filter.
• Do not install in direct sunlight.
• Installation must comply with existing state or local plumbing codes.
• It is essential that operational, maintenance and filter replacement requirements be carried out
for this product to perform as advertised. Change filter at least every six months. Flush new cartridge
into a bucket or pan for 5 minutes before connecting to refrigerator line. See Installation Instructions.
• What does this warranty cover?
— Any defect in materials or workmanship in the manufactured product.
• What does this warranty not cover?
— Filter Cartridges.
— Service trips to your home to teach you how to use the product.
— Improper installation, delivery or maintenance.
— Failure of the product if it is abused, misused, altered, used commercially or used for
other than the intended purpose.
— Use of this product where water is microbiologically unsafe or of unknown quality, without
adequate disinfection before or after the system. Systems certified for cyst reduction may
be used on disinfected water that may contain filterable cysts.
— Damage to the product caused by accident, fire, floods or acts of God.
— Incidental or consequential damage caused by possible defects
with this appliance, its installation or repair.
• For how long after the original purchase?
— Thirty (30) days.
• How do I make a warranty claim?
— Return to the retailer from which it was purchased, along with a copy of the "Proof of
Purchase." A new or reconditioned unit will be provided. This warranty excludes the cost
of shipping the product to your home.
REQUIRED TOOLS FOR INSTALLATION
• a tube cutter
• a knife
• a bucket or pan
.
Life
Pressure
25–125 psi
(172–862 kPa)
INSTALLATION PRECAUTIONS
215C1223P001 07-09 JR
GENERAL ELECTRIC COMPANY, Appliance Park, Louisville, KY 40225
Filter Replacement
OPTIONAL TOOLS FOR INSTALLATION
• a file
• sandpaper
SPECIFICATIONS
Max.
Tested
Temp.
Contaminant % Reduction
100°F
Chlorine
(38°C)
Particulate,
Class V
particles
30 to <50 μm
LIMITED 30-DAY WARRANTY
EXCLUSION OF IMPLIED WARRANTIES—Your sole and exclusive remedy is
product exchange as provided in this Limited Warranty. Any implied warranties,
including the implied warranties of merchantability or fitness for a particular
purpose, are limited to one year or the shortest period allowed by law.
This warranty is extended to the original purchaser and any succeeding owner
for products purchased for home or office use within the USA. In Alaska, the warranty
excludes the cost of shipping or service to your home or office.
Some states do not allow the exclusion or limitation of incidental or consequential
damages. This warranty gives you specific legal rights, and you may also have other
rights, which vary from state to state. To know what your legal rights are, consult your
local or state consumer affairs office or your state's Attorney General.
Contact us at GEAppliances.com, or call toll-free at 800.952.5039 in the U.S., or 866.777.7627
in Canada.
49-50246-2
GEAppliances.com
GXRTDR
System is Tested and Certified by NSF
International against NSF/ANSI Standard 42
for the reduction of Chlorine Taste and Odor
and Particulate Class V.
The GXRTDR has been tested and Certified by WQA
according to CSA B483.1.
% Reduction Influent Challenge
Required
Concn. Required
70%
≥50%
2.0 mg/L ± 10%
99.5%
85%
Min. 1000 #/ml
Replacement Filter Cartridges/Estimated Replacement Cost
GXRTDR–Replacement Filter $12—$17
For replacement parts, call toll-free 800.626.2002 (US),
800.663.6060 (Canada–English), or 800.361.3869
(Canada–French).
Average
Average
Influent
Effluent
2.0 mg/L 0.59 mg/L
5033 #/ml
24 #/ml

Publicidad

loading

Resumen de contenidos para GE GXRTDR

  • Página 1 Instructions GXRTDR Your new GE icemaker water filter comes complete with all the necessary hardware for installation. Each filter gives you up to six months of great-tasting water. Filter should be changed after 6 months of use. REQUIRED TOOLS FOR INSTALLATION OPTIONAL TOOLS FOR INSTALLATION •...
  • Página 2 GXRTDR Votre nouveau filtre à eau GE pour générateur de glaçons est fourni avec toutes les pièces nécessaires pour l’installation. Chaque filtre permet la production d’une eau d’excellente qualité pendant près de six mois. On devrait changer le filtre après 6 mois d’utilisation.
  • Página 3 GXRTDR Su nuevo filtro de agua GE para fábrica de hielo se surte completo e incluye todos los accesorios necesarios para la instalación. Cada filtro le brindará agua de excelente sabor hasta por seis meses. El filtro deberá cambiarse después de 6 meses de uso.
  • Página 4 Figure 2 Figure 3 Blue Locking Clip GXRTDR Installation if replacing GXRTQ or GXRTQR Inlet Tube Outlet Tube FLOW CUT HERE CUT HERE NOTE: If you are replacing a GXRTQ or GXRTQR model, cut tubing at A NOTE: Si vous remplacez un modèle de GXRTQ ou GXRTQR, coupez NOTA: Si usted está...