Publicidad
Idiomas disponibles
Idiomas disponibles
HEALTH AND SAFETY
This type of electrical appliance is designed for commercial and professional use, namely in restaurants,
canteens, hospitals and school kitchens, etc.
This dishwasher complies with the essential safety requirements of various European Directives.
Before installing and starting the dishwasher, you must read the instructions in this manual carefully, espe-
cially those concerning health and safety standards. This dishwasher is intended for professional use and
must only be used by properly trained personnel.
The dishwasher must be installed by professional experts in accordance with the manufacturer's instruc-
tions and in compliance with existing health and safety laws.
This dishwasher must be used solely for the purpose for which it has been specifically designed, i.e. the
washing of dishes and utensils held in racks. Any other use is to be considered improper, dangerous and
not recommended.
All maintenance operations must comply with and abide by these safety rules.
Routine maintenance on a DAILY basis; periodic maintenance once every 2 weeks.
Always place a warning sign reading "wet floor"
area becomes wet underfoot.
Always contact an expert technician should the ma-
1. INTRODUCTION
This appliance is equipped with following technical documents:
- Manual "INSTALLATION AND USE" (which you are reading)
- technical sheet
- wiring diagram
- Declaration of Conformity to EC Directive
The instructions contained in this manual provide important information regarding safety for installing, operating
and maintaining the appliance. The manufacturer recommends to carefully store this manual near the machine
where it can be consulted by technicians and operators.
The installation must be carried out according to the manufacturer's instructions and by professionally qualified and
expert personnel.
This appliance must be connected to supply mains through a fix main switch only.
Never leave packaging materials (plastic bags, polystyrene, nails, etc.) within reach of children since it can be
potentially dangerous.
Install the electric, water and drain lines in the wash area according to the instructions given in the technical sheet
of the machine.
2. SETTING UP THE APPLIANCE
Carry the machine to the installation site and remove its packaging materials. Check that the appliance is in perfect
condition. If it shows signs of damage, immediately inform the seller and the forwarder about this damage.
If there is any doubt do not use the appliance until it has been checked by authorised personnel.
THE MANUFACTURER CANNOT BE HELD LIABLE FOR DAMAGE CAUSED BY THE FORWARDER. THE
PERSON ACCEPTING THE DELIVERY IS RESPONSIBLE FOR CHECKING IT FOR DAMAGE AND SHOULD
SEND ANY CLAIMS DIRECTLY TO THE FORWARDER RESPONSIBLE FOR THE DAMAGE.
Place the machine in position and level it by rotating the adjustable feet.
To prevent damage caused by steam coming out of the appliance during normal operation, make sure that the
materials nearby will not deteriorate if exposed to steam.
Before connecting the machine to the water supply and the electric mains, make sure that the general
characteristics and technical data indicated by the manufacturer on the data plate (C-3) and the technical sheet,
have been taken into due consideration during the preparation of the installation site. Operations must be carried
out exclusively with original parts. Only these, in fact, can guarantee perfect conformity of our machines with the
project data.
Unauthorised maintenance which is not carried out by qualified personnel and with non original spare parts, will
invalidate the guarantee.
Istruzioni originali Original instructions Instructions originales Originalanleitungen Instrucciones originales Rev. 3.00 del 14/02/2020 - pag. 18 di 72
near the machine whenever the surrounding
chine malfunction.
Publicidad
