Elframo D36 Serie Manual Del Usuario página 26

Alarm regeneration
20. Thermometer alarm (where fitted)
If the temperature probe is disconnected or interrupted the tank or boiler display
(A-7 or A-8) show
If the temperature probe is in short circuit or the temperature is higher than 107°C
the tank or boiler display (A-7 or A-8) show
21. Check-list
Before starting to use the machine, check the following:
1) The water level and its temperature.
2) The detergent level.
3) The rinse-aid level.
4) The temperature of the feeding water.
5) The washing agents (feeding tube filled, tank holes are clean).
Water must be distributed, at high pressure, from all the sprayers. The rotary wash and rinsing arms must be free
to rotate due to the water pressure. With every wash cycle the dispensers must draw the proper amount of rinse-
aid and detergent. Check the levels of the liquids in the containers and, if necessary, replace them or top them up.
The pump filter must be clean.
When the wash cycle is finished, the clean dishes must dry almost instantly by evaporation when the basket is
removed from the appliance.
Each time the machine is turned off with the A-1 button, it will start again from the last selected washing cycle when
turned on again. This occurs also when programs such as regeneration are used which automatically turn the
machine
off at the end of the cycle. The continuous washing cycle is never started automatically when the machine it turned
on.
If the machine is turned off by turning the mains power selector on the wall, the machine will restart from the normal
washing cycle when turned on again. The cycle may only be selected when the machine is not performing a cycle.
During all cycles the A-3 buttons (cycle selection) is deactivated.
22. Washing tips
Never put bare hands into the washing water. If this should happen, rinse immediately and thoroughly with cold
water. Put dishes, cups, glasses or cutlery in the appropriate baskets (B). The machine can be equipped with
different types of baskets, even stackable ones on request. Place the dishes in the relating basket with supports,
making sure that the dishes face upwards. Place cutlery and coffee spoons with their handles facing down. Do not
mix silver plated cutlery with stainless steel cutlery as the two materials would react and this would harm the
surfaces. When possible, wash glassware before other objects or wash with renewed tank water. To save on
detergent and electricity wash only when the baskets are full, but do not overload them. Do not stack the dishes.
WE RECOMMEND pre-cleaning the dishes in order to minimize machine maintenance. The quality of final wash
results will be greatly improved by first removing paper, food particles, lemon peels, toothpicks, olive pits, etc.
which could partially clog the tank filter and impair washing efficiency. We recommend washing the dishes before
food particles dry on their surface. It is good practice, when dried food scraps are involved, to first soak the dishes
in soapy water before introducing them into the machine.
23. MAINTENANCE
23.1. Routine maintenance
The tank MUST be cleaned at least twice a day or whenever there are solid particles in the tank filter. Remove the
tank filters (C-10) (if fitted) and clean them. Drain the water by unplugging the overflow pipe (C-2). Remove the
pump filter (C-4) and clean it. Clean the tank and remove any small residues and solid particles. Make sure that the
rotary wash arms are free to rotate. If the nozzle holes are clogged by solid particles, remove them with a fine
tipped tool. Put all the removed parts back into their position in reverse order. Leave the door open after the
working session. To avoid possible oxidation or chemical attack hazards in general, keep the steel surfaces of the
appliance clean.
NEVER USE THE MACHINE WITHOUT THE PUMP PROTECTION FILTER.
23.2. Periodic maintenance
(to be done at least every 2-3 days)
NOTE: do not wash the appliance with high pressure or direct jets of water since water could penetrate into
electrical devices and prejudice the efficient operation of the appliance and its safety systems. Non-observance of
this instruction invalidates the guarantee.
•
Drain the water completely from the appliance.
•
Turn the appliance off by pressing the button ON/OFF button.
•
Turn off the electric power supply by disconnecting the main switch installed upstream from the appliance.
Istruzioni originali Original instructions Instructions originales Originalanleitungen Instrucciones originales Rev. 3.00 del 14/02/2020 - pag. 26 di 72
Blinking 1 sec. period.
EN