Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS (CONTINUED)
14. Move the mantel into its final position against
the wall. Use a pencil or painters tape to mark
the location of the opening in the back panel as
a guide.
Move the mantel away from the wall and use
the marking you made as a guide for location
of the TV mount. Follow the TV mount
manufacturer's instructions for proper
installation.
Note: Must use a "Full-Motion TV Mount"
(not included). Fixed and tilting TV mounts
CANNOT be used with this mantel. There are
many types and shapes of TV mounts, the TV
mount shown in the drawings is for reference
only.
Note: Opening size is
24 1/2 in w x 13 1/8 in h
15. With TV mount fully extended, move mantel
closer to wall and guide TV mount through
opening in back panel.
Leave a gap between the mantel and the wall
approximately 6-10 inches to allow access to run
TV power and AV cables behind the mantel.
Mount the TV onto the bracket, then feed the TV
power and AV cables from the TV through the
opening behind the mantel accordingly.
Note: Check to make sure the TV and all AV
equipment work as expected before moving
mantel into final position against the wall.
Note: Make sure to install the tip restraints
(directions below)before pushing the mantel
against the wall.
TV Mount
Not Included
15
14
15
6-in to 10-in
Gap from Wall
Publicidad
