Publicidad
Honda_HR-V
2.0
Fuse
Fuse
5A
15A
Relé
LPG EV
WARNING:
- Follow carefully petrol and gas injectors sequence as shown in the diagram.
- Never connect front and back Solenoid Valve cables to the Ground.
- In order to make a front and back Solenoid Valve right diagnostic, don't connect them to each other.
- Never replace fuses with another ones with bigger amperage.
CAUTION:
Be careful with the cars for which the manufacturer prohibits or advises against disconnecting the battery, not to alter the antitheft devices or automatic adaptivity -
Never use welders connected to the battery of the same car - Connect with suitably insulated soft solderings - Position the BRC electrical devices in a well ventilated
area, protected from water seepages and heat sources - We recommend to insulate the BRC electronic control unit wires which are not connected - BRC reserves the
right to modify this diagram without notice - We also recommend you to be sure to have the last revision of the diagram drawn up by BRC.
M.T.M. Srl
SEQUENT DIRECT INJECTION 2.0
Honda HR-V 1.5 2WD 16V 96kW L15B4 EURO 6B Man. GPL
Multipoint Electronic Injection
Changeover
Switch
*
Extend the wire up to
the ECU
Gas Pressure
1
2
3
4
and
Temperature
Sensor
Gas
Inlet
Gas Injectors Sequence
Wiring diagram
Diagnostic
Point
Red
3
2
1
Black
Black
Black
Red
Red
*
Pin n° 1 Conn. A Black
Cut and
Cut and
insulate
insulate
Pin n° 2 Conn. A Black
singularly
singularly
Pin n° 4 Conn. A Black
Pin n° 22 Conn. B Grey
Pin n° 28 Conn. B Grey
Pin n° 36 Conn. C Green
Pin n° 2 Conn. B Grey (1° Injector Signal)
Pin n° 1 Conn. B Grey (1° Injector Positive)
Pin n° 6 Conn. B Grey (2° Injector Signal)
Pin n° 5 Conn. B Grey (2° Injector Positive)
Pin n° 8 Conn. B Grey (3° Injector Signal)
Pin n° 7 Conn. B Grey (3° Injector Positive)
Pin n° 4 Conn. B Grey (4° Injector Signal)
Pin n° 3 Conn. B Grey (4° Injector Positive)
Sensor
temperature
water
DO NOT CONNECT
DO NOT CONNECT
Petrol
Injectors
Sequence
8|8
Date:
Diagram n°:
In place of diagran n°:
Draftsman
Signature:
Level sensor connector
Tagliare ed isolare
Rear Solenoid Valve Connector
Warning: CAN BUS connection
can NOT be made on diagnostic
socket level, but it MUST be made
+
-
on petrol ECU connector level.
Battery
A
B
C
1 2 3 4 5 6 7 8 9 10
12 13 14 1516 17
18
22 23 24 25 26 27
A
B
C
31 32 33 34 35 36
37 38
42 43 44 45 46 47 48 49 50 51
Wires side view
Petrol
ECU
Pin n° 35
Conn. C Green
White (MAP)
Sensor
Map
MV
18_09_18
2
05.12.18
I.C.
19 20
21
28 29 30
39 40 41
fusibili
FSG000065R-2
Publicidad
