Glacier bay 20203-9010H Guía De Uso Y Mantenimiento página 5

Installation
1
Marking the mounting location
□
Remove the set screw (DD) from the base of the
product posts.
□
Place the product in the desired mounting
location, using a level to position it accordingly,
and use a pencil to lightly mark the outline of the
post(s).
□
Center the mounting bracket (BB) within the
marked post location(s), and mark where the
screw holes will be drilled.
□
Repeat this step as needed for each bath
accessory.
NOTE: The included template (EE) may be used to mark the
mounting locations for the towel bars: A and D for the 24
in. towel bar.
3
Installing the product
□
Place the post (A or D) over the mounting
bracket (BB) and secure it with the set
screw (DD), as shown.
□
Repeat this step for the remaining post (D or A).
NOTE: Ensure the towel bar is inserted prior to securing
the second post to the mounting bracket (BB).
DD
BB
2
Installing the mounting brackets
□
Drill 1/4 in. holes in the previously marked
locations.
□
Push the plastic anchors (CC) flush into the dry wall.
□
Fasten the mounting bracket (BB) to the wall with
the wood screws (AA).
□
Repeat this step as needed for each bath
accessory.
NOTE: When mounting the products to a wood wall, fasten
the mounting brackets (BB) to the wall using the wood
screws (AA). There will be no need for drilling or plastic
anchors (CC).
5
Please contact 1-855-HD-GLACIER for further assistance.
CC
AA
BB
AA
BB
BB
DD
HOMEDEPOT.COM/GLACIERBAY