Publicidad
Idiomas disponibles
Idiomas disponibles
Keep third parties away from the pneumatic tool's
area of operation. Never work while animals or
people, especially children, are in the danger zone.
Keep the work area clean, organized and well lit (250 to 300
lux light), thus decreasing the risk of accidents.
Always wear personal protective equipment and clothing.
Wearing a visor or goggles, dust mask, hearing protection,
anti-slip safety shoes, long-sleeved clothing, gloves and
helmet properly reduces the risk of injury.
Clothes worn when using the machine must be suitable,
tight-fitting and closed, for example, a work boilersuit. Do
not wear loose clothing or jewellery. Keep hair, clothing and
gloves away from moving parts.
To ensure that the pneumatic nail/staple gun is used in a
safe way, to make it easier to change accessories, to
optimise the operation of the machine and to extend its
service life, certain precautions and procedures must be
considered such as:
▪ The air pressure supplying the machine must not exceed
the
maximum
pressure
specifications;
▪ The compressed air system must have a filter capable of
regulating the working pressure, eliminating liquid and
solid particles and lubricating the machine. This keeps
the nail/staple gun lubricated and reduces friction;
▪ Drain the pressure regulator cup daily. The presence of
water in the compressed air system can cause damage
to the machine mechanism;
▪ The compressed air line shall be composed of a 3/8"
diameter hose;
▪ Never use a compressed air hose for pulling,
transporting the pneumatic tool. Damaged hoses
increase the risk of accidents and injuries;
▪ Keep the air hose away from heat sources, oil, sharp
objects and rotating parts. If the air hose is damaged, it
should be replaced;
▪ Constantly check the condition of air hoses and
couplings to detect and prevent air leaks;
▪ The compressed air system must have a shut-off valve
that cuts off the compressed air supply in the event of
an emergency.
given in
the
technical
Disconnect the machine from the compressed air
supply line before carrying out any cleaning,
adjustment, accessory replacement, repair or maintenance
work.
Cleaning:
Always keep the pneumatic nail/staple gun clean and dry.
Clean all pneumatic air grinder's components and
accessories after operation.
Always keep the handle free from oils, lubricants or grease.
Do not use aggressive cleaning products. These products
may damage plastics and metals, compromising the safe
operation of the pneumatic tool.
Maintenance:
Replace worn out or damaged parts immediately, so that
the pneumatic tool is always in a safe operating condition.
Keep all bolts and nuts well tightened to ensure a safe
operation.
Only maintenance works described in this instruction
manual may be carried out, all other works must be
performed by an official dealer.
Use only VITO-approved tools and attachable accessories
for this machine or technically identical parts. Failure to do
so may result in personal injuries or damages to the
pneumatic nail/staple gun. If in doubt, if you lack
knowledge or resources, you should contact an official
dealer.
The pneumatic nail/staple gun should only be serviced by
the brand's technical assistance center, or other qualified
personnel, replacing any necessary parts with original
ones.
Publicidad
