Publicidad
Idiomas disponibles
Idiomas disponibles
1. Insert the compressed air hose into the air inlet
coupling.
Staples:
1. Press the magazine loading lever (4) and open the
magazine (5);
2. Insert the staples in the magazine;
3. Close the magazine until it clicks back into place.
Nails:
1. Press the magazine loading lever (4) and open the
magazine (5);
2. Place the nails according to the markings on the
nail/staple gun head (9);
3. Close the magazine until it clicks back into place.
1. Connect the compressed air hose to the air inlet
coupling (2);
2. Touch the head (9) firmly to the workpiece to activate the
safety catch (10);
3. Press the trigger (3) to fire staples/nails.
If the head is not in contact with the workpiece and the
safety catch mechanism is not pressed down, the trigger
will not function for safety purposes.
The nail/staple gun should only be operated continuously
for a maximum of 30 minutes. After this time, allow it to rest
so as not to damage the equipment.
When you are not using the nail/staple gun,
disconnect the compressed air hose and remove the
staples/nails.
The nail/staple gun is equipped with an impact control
knob (8) so that you can adjust the impact force according
to the workpiece material where you will use the machine.
Before you start operating, adjust and test the
optimum impact force on spare material.
Publicidad
