Publicidad
Idiomas disponibles
Idiomas disponibles
Maintaining your appliance
After a steam-cleaning cycle
•
Take care when opening the door before a steam-cleaning procedure has
ended. The water on the bottom is hot.
•
Open the oven door and remove the remaining water with a sponge. Do not
leave the residual water in the oven for any length of time. Wipe the oven
clean and dry with a soft cloth. Do not forget to wipe under the oven door
seal.
•
Use a detergent-soaked sponge, a soft brush, or a nylon scrubber to wipe the
oven interior. Remove stubborn residue with a nylon scourer. You can remove
lime deposits with a cloth soaked in vinegar.
•
If the oven remains dirty, you can repeat the procedure once the oven has
cooled.
•
For heavy residue, such as grease left over from roasting, we recommend
that you rub detergent into the residue before activating the steam-cleaning
function.
•
After cleaning, leave the oven door ajar at a 15° angle to allow the interior
enamel surface to dry thoroughly.
50 English
NE63B8611-03_IB(FULL)_EN+MES+CFR.indb 50
NE63B8611-03_IB(FULL)_EN+MES+CFR.indb 50
Care and cleaning of the oven
WARNING
•
Be sure all controls are OFF and all surfaces are COOL before cleaning any part
of the range.
•
If your range is moved for cleaning, servicing, or any
reason, be sure the Anti-Tip device is re-engaged
properly when the range is replaced. If you fail to re-
engage the Anti-Tip device, the range could tip and cause
serous injury.
Vent
•
Vent
Vent
•
•
•
The vents are located at the back of the
oven range.
This area could become hot during oven
use.
It is normal for steam to come out of
the vent.
The vent is important for proper air
circulation. Never block this vent.
2023-10-13 오후 2:14:18
2023-10-13 오후 2:14:18
Publicidad
