Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Information codes
OVEN
Displayed
Possible cause
Code
There is a short in the control
C-d0
key.
C-d1
The door lock is misaligned.
This code occurs if
communication between
C-F0
the Main and Sub PBA is
interrupted.
This code occurs if
C-F2
communication between the
Main and Touch is interrupted.
The oven sensor is open when
the oven is operating.
C-20
There is a short in the Oven
sensor.
This code occurs if the internal
temperature rises abnormally
C-21
high.
The sub PCB sensor is open
when the oven is operating.
C-22
There is a short in the sub PCB
sensor.
The main PCB sensor is open
when the oven is operating.
C-30
There is a short in the main PCB
sensor.
62 English
NE63B8611-03_IB(FULL)_EN+MES+CFR.indb 62
NE63B8611-03_IB(FULL)_EN+MES+CFR.indb 62
Solution
Press OFF/CLEAR, and then
restart the oven. If the problem
persists, disconnect all power
to the range for at least 30
seconds and then reconnect the
power. If this does not solve the
problem, call for service.
Press OFF/CLEAR, and then
restart the oven. If the problem
persists, disconnect all power
to the range for at least 30
seconds and then reconnect the
power. If this does not solve the
problem, call for service.
Displayed
Possible cause
Code
This code occurs if the PCB
temperature rises abnormally
C-31
high.
This error message appears
bAd LinE
if the power cord is installed
improperly.
This code occurs if the sub PCB
C-A2
temperature rises abnormally
high.
Solution
Call for service.
If the power connection is
plugged in improperly, "bAd
LinE" appears on the display.
Reconnect the power connection
properly, and the message
disappears.
Press OFF/CLEAR, check the
vent. If the vent is closed, never
block the vent by anything.
After cooling the oven, restart
the oven. If this does not solve
the problem, call for service.
2023-10-13 오후 2:14:20
2023-10-13 오후 2:14:20
Publicidad
