ESISTYLE Butterfly Manual De Instrucciones página 17

Ceiling installation:
To install the appliance, use expansion anchors and screws which are suitable for your
type of wall (reinforced concrete, plasterboard, etc.)
RECIRCULATION mode (fig. 8 – 9)
Caution! Charcoal filters shall be ordered at your retailer's.
MAINTENANCE
CAUTION! Disconnect the hood from power supply before carrying out any cleaning or
maintenance operation, by removing the power cord or disconnecting the main power
switch.
Cleaning
The appliance shall be cleaned quite often, both internally and externally, using a cloth
dampened with tepid water and a non-abrasive, neutral liquid detergents.
Metal grease filters (fig. 12)
They capture grease particles from cooking fumes and protect the motor, therefore they
can obstruct at various times depending on the use of the appliance. These filters can be
washed in the dishwasher, with short washing cycles at low temperature, maximum every
two months in order to prevent fire risk Filters may change in color after several washings:
this will not entitle users to claim for replacement.
Charcoal filters
They capture odors and purify the air which is then re-conveyed into the room.
- Charcoal filters are neither washable nor renewable and shall be replaced every 4
months. Charcoal filters saturation depends on how much you use your hood. To replace
charcoal filters, open the panel, remove the metal grease filter and then remove the
charcoal filters (fig. 12 – 8).
- Renewable charcoal filters can be washed in the dishwasher at a maximum temperature
of 65° (complete washing cycle without dishware) or hand-washed using non-abrasive
neutral detergents. Remove excess water having care not to damage the filter, place it in
the oven for 10 minutes at 100°C in order to dry it (fig. 12 – 9).
Replace the pad every 3 years or every time the cloth is damaged.
Lighting
The hood is equipped with a LED technology-based lighting system whose main features
are high efficiency, low consumption and very long life-time under normal use conditions.
Contact the technical assistance service to replace lighting.
THE MANUFACTURER declines all liabilities for any damages resulting from
incorrect installation or misuse of this appliance
17