ESISTYLE Butterfly Manual De Instrucciones página 19

• Introduce an exhaust pipe inside the truss and connect it to the connecting ring of the
engine compartment (exhaust pipe and fixing clamps not supplied).
• Drill in correspondence with the holes on the flange, insert the anchors to the ceiling and
fix definitively with screws and washers (11) IMPORTANT: SAFETY SCREWS.
• ONLY FOR FILTER VERSION: mount the T filter fitting and fix it to the structure with 4
screws; insert the CIRCULAR type charcoal filters (12) directly on the engine, or the
LONG-LIFE type (13), to the grease filter
• Make the electrical connection, connect the pipe at the top (if FILTERING, connect the
pipe to the T fitting) and check correct operation.
• Fix the upper chimney divided into two pieces (14) with 4 screws, make the magnet
adhere correctly along the joint (15).
• Apply the L-shaped frames to the shelf using 4 screws Ø 3,9x7 Fig.15
• Position the lower chimney divided into two pieces, making sure the magnet (16) adheres
correctly.
19