Argoclima aYRI Instrucciones De Uso página 4

WARNING: ALWAYS OPEN the AIR OUTLET GRILLE BEFORE USING THE APPLIANCE
OPERATION
COOLING
• Place the air conditioner as near as possible to the window.Connect exhaust hose kit to the back of t.
the unit. Extend the flexible tube just enough to reach the outdoor, passing under the win-
dow shutters set ajar.
• In case there is a window sill towards the inside of the room, it might be better to use the supplied
outlet nozzle. Insert the nozzle into the free end of the flexible tube.
• Open the window and lock one of the shutters. Place the outlet nozzle between the two shutters.
EG
• Avoid sharp bends or plies of the flexible tube.
• In case of porthole utilise make a 135 mm diameter hole in the window pane.
• Switch on the air conditioner pressing
• Select the cooling operation pressing
• Press SPEED to select the fan speed (High, Medium, Low) to suit your desired comfort level.
• To stop the air conditioner press again
NOTE
The minimum temperature is 16°C and the maximum temperature is 32°C.
DEHUMIDIFICATION (DRY)
• When the air conditioner is in dehumidification mode, it doesn't cool the room.
• Press
to start the air conditioner.
• Select dehumidification mode pressing
• When you use the air conditioner in the dehumidification mode, you don't have to use the flexible tube.
• For maximum dehumidification efficiency leave the rear discharge outlet free to discharge directly into the room.
• Continuous drainage is then necessary.
• To stop the air conditioner press again
NOTE
Fan speed can't be adjusted in dehumidifcation mode; fan speed operates in "medium" speed. This function is recommended
in autumn and winter. When you use this function in summer, please use the flexible tube.
FAN
•
Press to start the air conditioner.
•
Select fan mode pressing
•
Air is circulated throughout the room without cooling.
•
To stop the air conditioner press again press again
NOTE
Unit does not need to be vented in fan mode. Fan speed control has 3 settings: Hgh, Medium, Low
LAMP FOR FULL TANK
Condensed water may accumulate in the unit. If the internal water tank becomes full, the warning lamp will shine and the unit will
not operate until the unit has been drained (see the section on DRAINING).
TIMER
Auto turn off: with the unit in running mode, press timer touch control to select number of hours You would like the unit run in air conditioning
mode, until automatically shuts off.
Auto turn on: with the unit in stand-by mode, press timer touch control to select number of hours after which You would like the unit
automatically start running in air conditioning mode.
TIMER / Temp set controls
• Used to adjust timer and thermostat.
• The temperature on default display is room temperature.
• In cooling mode, when one of these touch controls is pressed, the set temperature is displaied and may be adjusted. After 15 seconds
the display goes back to room temperature. Temperature is adjustable only in coolig mode. The time is adjustable from 1 to 24 hours.
NOTE: by pressing both Timer and Temp set controls at the same time, the display will toggle between Celsius and Fahrenheit
4
the indicator symbol
, the indicator symbol
, the indicator symbol turns.
turns.
turns.