Skil PSS1200 Manual Del Propietário página 12

ASSEMBLY
WARNING
parts, making adjustments, cleaning, or when not in use .
WARNING
could result in serious personal injury.
Connecting the Snow Shovel Attachment to the Power Head
WARNING
Installing the attachment
a. Remove the battery pack from the power
head.
b. Loosen the wing knob on the power head
shaft (Fig. 2a).
c. The power head has two grooves on the
coupler, ONLY the groove 1 is used to
connect an attachment.
d. Align the spring-loaded pin on the
attachment shaft with the groove 1 on the
coupler and push the attachment shaft into
the power head shaft until the pin pops
out of the groove and you hear an audible
"click" sound at the same time (Fig. 2b).
e. Pull the attachment shaft to verify that it is
securely locked into the coupler.
f. Tighten the wing knob securely.
Removing the attachment
(Fig . 2c)
a. Remove the battery pack.
b. Loosen the wing knob.
c. Press down the spring-loaded pin and pull
the attachment shaft out of the coupler.
12
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the tool when assembling
If any parts are damaged or missing, do not operate this product until
the parts are replaced .
Never operate the power head without an attachment .
Use of this product with damaged or missing parts
Fig . 2a
Power-Head Shaft
Fig . 2b
Groove 1
Fig . 2c
Groove 2
Coupler
Wing Knob
Groove 1
Attachment Shaft
Pin
2
1
Pin