Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Information
1. If charging, unplug the charger. Do not remove the battery
pack.
2. Step away from the battery pack.
3. Leave the battery pack for 12 hours.
4. Contact your Rodcraft representative.
The product should be stored in a dry place with good ventila-
tion.
Product Specific Instructions
Operation
Charging The Battery
Refer to Schema 4 and Schema 5:
The charger is equipped with a green battery charge status in-
dicator light (3) and a red battery charge status indicator light
(4) . During charging, the red indicator light will light up. Af-
ter completion of charging, the green indicator light will light
up and the red indicator turns to light off.
1.
Connect the charger (2) to a suitable mains socket. The
green charging indicator light comes on.
2.
Slide the battery (1) onto the charger along with the Bat-
tery interface (5), the red indicator charging light comes
on.
3.
The charger may become warm and buzz slightly during
charging. This is normal and does not indicate a fault.
Please ensure that:
• Make sure that the contacts on the battery and the
contacts on the charger are clean and dry.
• Make sure that the battery always engages correctly.
• Charge the battery fully before using it for the first
time.
• Push the battery into the battery holder until it en-
gages with an audible click.
• Check that the battery is seated securely.
Removing The Battery
1.
After about one hour or two hours later the green charg-
ing indicator will light up to indicate that charging is
completed.
2.
Disconnect the charger from the main socket after
charging.
3.
Pull the battery out of its holder in the device.
Maintenance instructions
1.
Disconnect the charger from any AC outlet before
cleaning.
2.
Clean out dust and debris from charger vents and elec-
trical contacts. Use a damp cloth.
3.
Do not use liquid or spray detergent for cleaning.
Do not modify or attempt to repair the charger.
For safety reasons, the charger should be serviced only by the
manufacturer or authorized service providers.
6
If one of the following situations arises, get the charger
checked by the manufacturer or authorized service providers.
a. The power cord or plug is damaged.
b. Liquid has penetrated into the charger.
c. The charger has been exposed to moisture.
d. The charger does not work well, or you cannot get it to
work according to the user's manual.
e. The charger has been dropped and damaged.
f. The charger has obvious signs of breakage.
Symbol
T3.15A
Useful Information
Country of origin
People's Republic of China
Website
Information concerning our Products, Accessories, Spare
Parts and Published Matters can be found on the Rodcraft
website.
Please visit: www.rodcraft.com.
Safety Data Sheet
The Safety Data Sheets describe the chemical products sold
by Rodcraft.
Please consult the Rodcraft website for more information
qr.cp.com/sds.
Copyright
© Copyright 2023, Desoutter GmbH, Edmund-Seng-Str. 3-5,
63477 Maintal, Germany
All rights reserved. Any unauthorized use or copying of the
contents or part thereof is prohibited. This applies in particu-
lar to trademarks, model denominations, part numbers, and
drawings. Use only authorized parts. Any damage or malfunc-
tion caused by the use of unauthorized parts is not covered by
Warranty or Product Liability.
© Rodcraft - 8956002313
Please read the instructions carefully before
starting the machine.
Time-lag fuse 3.15 A
Class II tool.
This tool is only suitable for indoor use. Never
expose tool to rain.
Do not dispose of electric tools together with
household waste material. Electric tools and
electronic equipment that have reached the end
of their life must be collected separately and re-
turned to an environmentally compatible recy-
cling facility. Check with your local authority or
retailer for recycling advice and collection point.
Battery Charger
Publicidad
