Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Problem
Status LED does
not flash.
Status LED
flashes red.
eStore does not
respond to press-
ing of the main
switch command.
22
Cause
eStore is in storage mode.
eStore is over discharged.
eStore is defective.
eStore is configured to be
connected to multiple eStores
and BUS cables are not
plugged in.
eStore ist defective.
eStore is in storage mode.
eStore is over discharged.
eStore is configured as slave
and not as master.
Configuration for connecting
multiple eStores is faulty.
eStore is defective.
Remedy
➤ Activate eStore.
➤ Charge eStore with a
charging current of <10 A.
Note: Do not use intelligent
charging systems (with
main swtich open, the
eStore terminals have no
voltage. Some intelligent
battery chargers do not
start if no voltage is pre-
sent).
➤ Contact an authorised
workshop.
➤ Plug in eStore cables.
➤ Contact an authorised
workshop.
➤ Activate eStore.
➤ Charge eStore with a
charging current of <10 A.
Note: Do not use intelligent
charging systems (with
main swtich open, the
eStore terminals have no
voltage. Some intelligent
battery chargers do not
start if no voltage is pre-
sent).
➤ Use main switch command
on master eStore (eStore
configured #1)
➤ Check the configuration.
➤ Contact an authorised
workshop.
eStore
EN
Publicidad
