Rc Panel Basic /Bt: Connecting The Remote Control To The Power Source Via Bluetooth - Fronius RC Panel Basic Manual De Instrucciones

RC Panel Basic /
1
BT: connecting
2
the remote con-
trol to the power
source via Blue-
tooth
3
Beware when switching the remote control on/off:
Leave the remote control for at least 3 seconds after switching off, otherwise the switch off
will not be detected.
If the device is switched on again too quickly after it has been switched off, the indicator
light illuminates for less than 3 seconds.
38
Switch on remote control at the indicator light
Switch on power source and activate Bluetooth function
The remote control is ready to use when this is detected and displayed by the power
source.
Confirm Bluetooth settings on the power source if necessary