Publicidad
Idiomas disponibles
Idiomas disponibles
1
5
OPERATING INSTRUCTIONS: WET VACUUMING
The vacuum can be used for wet pick up with or without the use of the crevice tool.
For use with the crevice tool:
1. Verify that the switch is in the OFF position before plugging in (Fig. 1).
2. Insert the the crevice tool to the end of the dust cup until secured in place (Fig. 2). The product can
be used with the crevice tool to clean up liquid messes between tight spaces.
3. Insert the plug into the 12V power socket (Fig. 3).
NOTICE: Vehicle will typically need to be in 'ACCESSORY' mode in order for power to be supplied to
the socket.
4. Turn the vacuum on by sliding the switch to the ON position and begin vacuuming (Fig. 4).
5. After use, turn the vacuum off and disconnect the plug from the 12V power socket (Fig. 5).
6. Remove the dust cup by pressing down on the dust cup release button and pulling the dust cup
away from the vacuum. Remove the reusable washable filter by pulling on the tab at the top of the
filter. Refer to page 9 for removal instructions.
7. Empty the dust cup, clean and dry the inside and outside before storage (Fig. 6 & 7).
8
IMPORTANT!
The vacuum is designed for vacuuming only small amounts of liquid.
STOP vacuuming if the liquid in the dust cup reaches the "MAX" indicator line on the dust cup (Fig. 8).
Empty it immediately before next use or storage.
2
6
7
8
3
4
Publicidad
