Publicidad
Idiomas disponibles
Idiomas disponibles
1
4
6
CLEANING
WARNING: VERIFY THAT THE POWER PLUG IS DISCONNECTED FROM THE SOCKET.
NOTICE: The filter is re-usable and should be cleaned regularly. Clean or change the filter regularly for
best performance.
WARNING: IF THE MACHINE IS USED WITHOUT THE FILTER, THE MOTOR WILL BURN
OUT AND THE WARRANTY WILL BE VOIDED. ALWAYS KEEP SPARE FILTERS ON HAND.
NOTICE: A dry filter is necessary to pick up dust. If the filter is wet, it will clog quickly and be very
difficult to clean. If wet, let the filter completely air dry before using it for dry pick-up. Handle the filter
carefully when removing it for cleaning and replacing it. Check the filters for tears or small holes. A
small hole can let dust pass through and out of the filter. Do not use a filter with holes or tears; replace
it immediately.
1. Verify that the plug is disconnected from the 12V power socket.
2. Press the release button and remove the dust cup (Fig. 1 & 2).
3. Remove the reusable washable filter from the dust cup by pulling on the tab at the top of the filter,
then clean any loose dust off the filter with a soft bristle brush (Fig. 3).
4. Empty all debris and any dust from the dust cup (Fig. 4).
5. Use a mild soap and water solution to wash the filter and rinse with clean water, air dry and re-insert
filter once completely dry (Fig. 5).
6. Allow the wet filter to air dry for 24 hours before fitting into the dust cup. For optimal performance, a
new filter is recommended.
7. Make sure the dust cup and filter are clean and dry before using it again. DO NOT immerse the
vacuum in water (Fig. 6).
8. Refit the reusable washable filter into the dust cup (Fig. 7).
9. Refit the dust cup onto the vacuum. Make sure the dust cup clicks into place (Fig. 8).
MAINTENANCE
5
7
2
9
3
6
Publicidad
