Makita DUC256 Manual De Instrucciones página 11

FUNCTIONAL
DESCRIPTION
CAUTION: Always be sure that the tool
is switched off and the battery cartridge is
removed before adjusting or checking func-
tion on the tool.
Installing or removing battery
cartridge
CAUTION: Always switch off the tool
before installing or removing of the battery
cartridge.
CAUTION: Hold the tool and the battery
cartridge firmly when installing or removing
battery cartridge. Failure to hold the tool and
the battery cartridge firmly may cause them to
slip off your hands and result in damage to the
tool and battery cartridge and a personal injury.
Fig.3
► 1. Red indicator 2. Button 3. Battery cartridge
To remove the battery cartridge, slide it from the
tool while sliding the button on the front of the
cartridge.
To install the battery cartridge, align the tongue
on the battery cartridge with the groove in the
housing and slip it into place. Insert it all the way
until it locks in place with a little click. If you can
see the red indicator as shown in the figure, it is
not locked completely.
CAUTION: Always install the battery
cartridge fully until the red indicator cannot
be seen. If not, it may accidentally fall out of
the tool, causing injury to you or someone
around you.
CAUTION: Do not install the battery car-
tridge forcibly. If the cartridge does not slide
in easily, it is not being inserted correctly.
Indicating the remaining battery capacity
Fig.4
► 1. Battery indicator 2. Check button
Press the check button to indicate the remaining battery
capacities. The battery indicators correspond to each battery.
Battery indicator status
On
1
2
3
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
Fig.5
► 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge
to indicate the remaining battery capacity. The
indicator lamps light up for a few seconds.
11 ENGLISH
1 2
Off
Blinking
1
Remain-
ing
battery
capacity
50% to
100%
20% to
50%
0% to
20%
Charge
the
battery
2