Sagem PHOTO EASY 160 Manual Del Usuario página 6

Liasse AZUR_GB.book Page 2 Jeudi, 21. avril 2005 4:09 16
Safety instructions and recommendations
• Do not install your photo printer in a humid room (bathroom, laundry,
kitchen, etc.), or within 1.50 m of a tap or water source, or outside. The
printer should be operated within an ambient temperature range of 10 °C to
35 °C. Your printer should be used at an ambient temperature of between
15°C and 35°C for optimum printing results.
• Do not set up your printer in a dusty environment as dust deposits might
adversely affect the print quality of your photos.
• Only the power supply provided with the printer should be used. Connect
this to the mains in accordance with the installation instructions in this user
guide and the information on the identification label affixed to the power
supply (voltage, current, mains frequency). As a precaution, in case of
danger, the mains adapters act as a disconnecting mechanism for the 230V
power supply. They should be placed near the device and should be easily
accessible.
• Never open the cover of the film cartridge compartment during printing.
This could break the film and cause printer malfunction.
• Only use SAGEM consumables, if not you are likely to damage the
equipment and invalidate the guarantee. To obtain the references of the
consumables (Refer to paragraph Replacement of consumables, page -33).
• The CE marking certifies that the product meets the main requirements of
the European
telecommunications terminal equipment, regarding safety and health of
users, and regarding electromagnetic interference.
The declaration of compliance can be consulted on the site www.sagem.com
category "support", or can be requested at the following address:
4 rue du Petit Albi - 95800 Cergy Saint-Christophe - FRANCE
Parliament and Council
E - Customer relations department
- 2 -
directive 1999/5/CE on