Sauder Beginnings Serie Manual Del Usuario página 11

Step 7
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (H) and lay it over your unit.
Make equal margins along all four edges of the BACK (H). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (H) to your unit using the NAILS (1N).
å
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed.
Fasten the FEET (1E) to the BOTTOM (F). Use four BLACK
å
9/16" PAN HEAD SCREWS (51S).
1E
www.sauder.com/services
F
BLACK 9/16" PAN HEAD SCREW
(4 used for the FEET)
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
H
51S
413037
Caution
1N
NAIL
(22 used in this step)
Page 11