Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING
This product requires assembly.
Carefully remove the product and any accessories from the box.
Make sure that all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage or damage
occurred during shipping.
Do not discard the packing material until you have carefully inspected
and satisfactorily operated the product.
ASSEMBLING THE CHAIN SAW
Lift the quick release button of chain saw. Align the rear handle to the
groove and push it in. Ensure the release button snaps firmly into position
to lock the handle securely. (Fig. 1)
Quick release button
FIG. 1
INSTALLING/REPLACING THE GUIDE BAR AND CHAIN
DANGER: Never start the motor before installing the guide bar,
chain, sprocket cover and tension knob. Without all these parts
in place, the clutch can fly off or explode, exposing the user
to possible serious injury.
WARNING: To avoid serious personal injury, read and
understand all the safety instructions provided.
WARNING: Before performing any maintenance, make sure
the tool is unplugged from the power supply. Failure to heed
this warning could result in serious personal injury.
CATUION: Always wear gloves when handling the bar and
chain; these components are sharp and may contain burrs,
which can cause serious injury.
WARNING: Never touch or adjust the chain while the motor
is running. The saw chain is very sharp. Always wear
protective gloves when performing maintenance to the chain
to avoid possible serious lacerations.
NOTE: When replacing the guide bar and chain, use only
identical replacement parts.
1.
Disconnect the saw from power supply.
2.
Loosen the tension knob by turning counterclockwise.
3.
Remove the sprocket cover.(Fig. 3)
Tension knob
Sprocket cover
ASSEMBLY
PACKING LIST
−
Hedge Trimmer Cutting Head
−
Chain Saw Cutting Head
−
Trigger Handle
−
Bar Cover & Blade Cover
−
Owner's Manual
WARNING: If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this warning
could result in serious personal injury.
If any parts are damaged or missing, please call 1-800-313-5111 for
assistance.
ASSEMBLING THE HEDGE TRIMMER
Lift the quick release button of hedge trimmer. Align the rear handle
to the groove and push it in. Ensure the release button snaps firmly into
position to lock the handle securely. (Fig. 2)
Quick Release
Button
Rear
handle
Rear handle
4.
Remove the bar and chain from the mounting surface.
5. Remove the old chain from the bar.
6.
Lay out the new chain in a loop, and straighten any kinks.
The cutters should face in the direction of the chain
rotation. If they face backwards,turn the loop over.(Fig. 4)
FIG. 4
7.
Place the chain drive links into the bar groove.
NOTE: Make certain of the direction of chain.
8.
Position the chain so there is a loop at the back of the bar.
(Fig. 5)
9.
Hold the chain in position on the bar and place the loop
around the sprocket.(Fig. 6)
FIG. 3
6
Model CVP41810BB
Cutter Direction
FIG. 2
FIG. 5
FIG. 6
Publicidad
