Inserting The Battery - Silvercrest SKRD 30 A1 Instrucciones De Uso

Setting up and connecting

Inserting the battery

By inserting the battery you can avoid the loss of programmed time of day and
alarm times in the event of a possible power outage. The battery ensures that
the internal clock continues to run even during a power failure. When power is
restored the correct time appears automatically in the display
NOTICE
► The device can also be operated without a battery.
♦ Open the cover of the battery compartment
device by turning the cover to the left, with a coin, as far as it will go and
then lift off .
♦ Insert the battery type CR2032 (supplied) into the battery compartment.
The side with the marking + points upwards.
♦ Close the battery compartment by attaching the cover and then with a coin
turn it to the right.
Mounting under a wall cupboard
(Illustration see fold out side fi gure B)
With the supplied mounting plate
ple, a wall cupboard. For mounting of the device proceed as follows:
♦ Press both unlocking buttons
thereby, at the same time, sliding the mounting plate
remove the mounting plate
♦ Find a suitable set-up location for the device (see also the section
Requirements for the set-up location).
♦ Hold the mounting plate
of the mounting plate
cupboard so that, after Remove the mounting, the device is fl ush with the
cupboard.
♦ Mark the 4 fastening points with a pencil.
♦ Using a spike or nail, make a small depression at the respective marking
points. Screw the mounting plate
illustrated in fi gure B.
♦ Place the device aslant, with the front recesses in the top face, in the mount-
ing plate
plate
♦ Check to make sure that the device is secure.
SKRD 30 A1
you can mount the device under, for exam-
on the rear panel of the device downwards
20
.
under the set-up location. Thereby the front edge
should be approx. 3,5 cm behind the front of the
. Press the rear part of the device upwards against the mounting
until the device audibly locks into place.
3 .
on the underside of the
19
backwards and
tightly with the supplied screws as
GB
MT
87