Publicidad
Idiomas disponibles
Idiomas disponibles
Page 4
LIGHT ENGINE / LAMP ASSEMBLY REPLACEMENT
Open the unit and disconnect all
1
connectors from the charger board,
remove screws from the plastic
cover and charger board and take
them out.
Unscrew
screws
CHARGER BOARD REPLACEMENT
Disconnect input leads on the charger
1
board. Remove plastic cover from the
housing.
AFFINITY
2
Light engine
bracket
2
Main charger
board
Plastic cover
screws
Plastic cover
®
LIFE SAFETY SOLUTIONS
TEL: 800-705-SERV (7378)
techsupport-emergency@acuitybrands.com
MAINTENANCE
Remove the mounting screws from bracket and remove the lamp
assembly and carefully unplug connectors from lamp assembly.
Reconnect the connectors to the new lamp, reinstall the lamp assembly
and ensure that the lamp wires are not pinched.
Light engine/Lamp assembly
Disconnect all connectors from the
charger board.
Main charger
board screws
www.lithonia.com
Connectors
Remove all the screws from the
3
charger
board,
charger board. Connect the
connectors
in
orientation to the new charger
board.
© 2020, Acuity Brand Lighting,Inc.
replace
the
the
same
912-00021-002
Rev. CA, 2/2020
All Rights Reserved.
Publicidad
