Casals HA150032QEK Manual Del Usuario página 6

Downloaded by: pm_clarallort on 13-07-2023 15:30 CEST
USE:
- Connect the appliance to the mains.
- Select the appliance function desired (Fig. 1).
- Hammer drilling with rotation
- Set the selector (D) to (
- Turn the selector (C) until the arrow on the
appliance points to (
- Drilling without hammer action
- Set the selector (D) to (
- Turn the selector (C) until the arrow on the
appliance points to (
- Chisel without rotation
- Set the selector (D) to (
- Turn the selector (C) until the arrow on the
appliance points to (
- Place the appliance against the surface you
want to work.
- Press the appliance until the lengthways play is
taken up.
- Turn the appliance on, by using the on/off button
(E).
- Note: Exerting high pressure does not increase
machine effectiveness!
- WARNING: When the bit begins to penetrate
concrete or comes up against the reinforce-
ment rods in the concrete, the tool may react
dangerously. Make sure you keep your balance
by distributing your weight evenly and keeping
your feet in a safe position whilst holding the
tool firmly in both hands to avoid dangerous
reactions.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Stop the appliance by releasing the on/off
switch (E).
- Lubrification (Fig. 1).
- After approximately 50 hours the machines
must be lubricated.
- Open the cover if the lubrication point (G) using
a key.
- Apply an appropriate amount of grease to the
mechanism.
- Close the cover (G).
- WARNING: When the bit begins to penetrate
concrete or comes up against the reinforce-
ment rods in the concrete, the tool may react
dangerously. Make sure you keep your balance
by distributing your weight evenly and keeping
your feet in a safe position whilst holding the
)
)
)
)
)
)
tool firmly in both hands to avoid dangerous
reactions.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Allow it to cool before undertaking any cleaning
task.
- Clean the electrical equipment and the mains
connection with a damp cloth and dry. DO NOT
IMMERSE IN WATER OR ANY OTHER LIQUID.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- If the appliance is not in good condition of clean-
liness, its surface may degrade and inexorably
affect the duration of the appliance's useful life
and could become unsafe to use.
SUPPLIES
- Always use original supplies, designed specifi-
cally for your appliance model.
- These supplies are available in specialist shops.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if a product damage or other
problems arise. Do not try to dismantle or repair
without assistance, as this may be dangerous.
- If the connection to the mains has been
damaged, it must be replaced and you should
proceed as you would in the case of damage.
SPECIFICATIONS:
Rated power (W): 1500
Rated Voltage 230V~
No load speed (rpm): 0-880
Blows per minute (ipm) 0-4320
Impact Energy (J) 5,5
Maximum capacity in concrete (mm) 32
Weight (Kg:) 4.9