Publicidad
Downloaded by: pm_clarallort on 13-07-2023 15:24 CEST
Motor maintenance: always take the greatest
care over this and make sure that the motor
winding is not damaged and does not become
wet with oil or water.
The vents should always be kept clean and
free of obstacles.
Clean the machine thoroughly after each use.
CLEANING
Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an
acid or base pH such as bleach, or abrasive
products, for cleaning the appliance.
Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
Never submerge the appliance in water or any
other liquid or place it under running water.
If the appliance is not in good condition of
cleanliness, its surface may degrade and
inexorably affect the duration of the appliance's
useful life and could become unsafe to use.
SUPPLIES
Supplies can be acquired from distributors and
authorised establishments for your appliance
model. This appliance can use common
minigrinder tools.
These supplies are available in specialist
shops.
ANOMALIES AND REPAIR
Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
If the connection to the mains has been
damaged, it must be replaced, take the
appliance to an authorised technical support
service. Do not attempt to disassemble or
repair the appliance by yourself in order to
avoid a hazard.
SPECIFICATIONS:
Rated voltage:12V ⎓
Rated speed: n:5000-25000/min
Rated capacity: 25mm
Spindle thread size: M3.2
Diameter: 25mm
Weight: 0.42kg
Sound Pressure level (L
K
A = 3 dB
P
Sound Power level (L
K
A = 3dB
W
Vibration(a
)= 2.057 m/s
h
NB: These specifications are subject to change
without notice of purpose of improvement.
NB: By virtue of the conditions of fabrication
of this product, the maximum absorbed power
can differ from that specified.
NB: By virtue of the conditions of fabrication
of this product, the maximum used power can
differ from that specified.
The declared vibration total value and the
declared noise emission value given in this
information sheet have been measured
according EN 60745-1 and may be used to
compare one tool with other. It may also be
used in a preliminary assessment of exposure.
A) =60,3 dB(A),
P
A) =71,3 dB(A),
W
, K= 1.5 m/s
2
2
Publicidad
