Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
HOW
TO STOP
YOUR
UNIT
• To stop the
engine,
move
the
ON/OFF
switch to the OFF position.
_J
_r_j._
Switch
HOW
TO START
YOUR
UNIT
WAR NIN G:
Avoid any contact with the
muffler. A hot muffler can cause serious bums.
Starting
position
HELPFUL
I
!f your engine still does not
I start
after
following these
I
instructions,
pleas e Call
1-800-554-8723.
STARTING
A COLD
ENGINE
NOTE:
DO NOT squeeze
the throttle trigger
until the engine has started and runs.
1.
Set unit on a flat surface.
2.
Move ON/OFF
switch to the ON position.
3.
Slowly press the primer bulb 6 times.
4.
Move the start lever to the START
posi-
tion.
Primer Bulb
Start Lever
STARTING
A WARM
ENGINE
1.
Move ON/OFF
switch to the ON position.
2.
Squeeze
and hold the throttle
trigger.
Keep throttle trigger fully squeezed
until
engine runs smoothly..
3.
Pullstarter
rope sharply while squeezing
throttle trigger until engine runs.
NOTE:
Normally,
the warm
starting
proce-
dure can be used within
5-10 minutes
after
the unit is turned OFR if the unit sits for more
than 10 minutes without
being ran, it will be
necessary
to start the unit by following
the
steps under STARTING
A COLD
ENGINE or
following
the starting
instruction
steps shown
on the unit.
STARTING
A FLOODED
ENGINE
Flooded
engines
can be started
by p_acing
the ON/OFF
switch in the ON position.
Move
the start lever to the RUN position
and fully
squeeze
throttle trigger.
Pull the starter han-
dle repeatedly while squeezing
throttle trigger
until engine starts
and runs. This could
re-
quire pulling the starter
handle many times,
depending
on how badly the unit is flooded.
If
the
unit
still
doesn't
start,
refer
to
TROUBLESHOOTING
TABLE
or
call
1-800-554-6723.
OPERATING
THE
COUPLER
This model is equipped
with a coupler
which
enables
optional attachments
to be installed.
The optional attachments
are:
MODEL:
Edger .....................
PP1000E
Cultivator
..................
PP2000T
Blower
....................
PP3000B
Pruner
....................
PP5000P
'_
WARNING:
Always
stop unit and dis-
connect
spark plug before removing
or instal-
ling attachments.
REMOVING
TRIMMER
ATTACH-
MENT
(OR OTHER
OPTIONAL
ATTACHMENTS)
CAUTION:
When removing
or installing at-
tachments,
place the unit on a flat surface
for
stability.
1.
Loosen
the coupler
by turning
the knob
counterclockwise.
Upper Shaft
Coupler
Lower
Attachment
Starter Handte
5.
Pull starter rope handle sharply
until en-
gine starts and runs.
6.
Allow unit to run for 10-15 seconds, then
fully squeeze
the throttle trigger to disen-
gage the starting system.
TIGHTEN
Knob
2.
Press and hold the locking/release
button.
Publicidad
Tabla de contenido
