GOAL ZERO YETI PRO 4000 Guia Del Usuario página 9

Parallel Combining Solar Panels (600 Watt Max)
Nomad 100 Boulder 200
(100 Watts) (200 Watts)
8mm to HPP
adapter
Series Combining Solar Panels (3000 Watt Max)
Boulder 200 Ranger 200
(200 Watts) (200 Watts)
4-1 Series Combiner
(SKU 98715)
12
Boulder 200 Ranger 300
= 800 Watts
(200 Watts) (300 Watts)
4-1 Parallel Combiner
(SKU 98061)
Limited to
600W
going in
Ranger 300 Ranger 300
= 1000 Watts
(300 Watts) (300 Watts)
4-1 Series Combiner
(SKU 98715)
3-1 Parallel Combiner
(SKU 70030)
1000W
going in
For more information about integrating your Yeti PRO 4000 with solar, visit our
website at www.goalzero.com.
Car Charging
You can top off the Yeti while on the go using a vehicle's 12V Auxiliary Power
Outlet. Use a 12V Car Charging Cable (SKU 98740) to connect your Yeti to your
vehicle's 12V output.
12V
Car Cable
You can also have a licensed vehicle technician connect your Yeti PRO directly to
your alternator for 400W charging.
NOTE: The Yeti has built-in protection that prevents the car battery from
discharging below 11.8 V so it will never over discharge your vehicle's 12V battery,
even when the vehicle isn't running.
Automatic Power Switching (APS)
The product will automatically enter the Automatic Power Switching (APS) mode
when you are inputting power into the AC input port and simultaneously outputting
through the AC output. Power will pass directly from the grid or AC power source to
the loads connected to the Yeti and bypass the inverter of the Yeti. If grid power is
interrupted, power will quickly switch to Yeti power.
The Yeti PRO 4000 switches from grid to battery in under 15ms, but it does not
support 0ms switching. Some sensitive loads may be interrupted during the switch
over.
When using your Yeti Pro 4000 in APS mode, note that if the AC output of your Yeti
exceeds your set AC fast charge input limit the input will be disabled and your Yeti
PRO will run off of the internal battery until your AC output drops below your set
charge input limit.
8mm
Connector
13