Spengler AUTOTENSIO SPG440 Manual página 28

QUICK START
1. Install batteries. (See Figure A )
2. Insert cuff air plug into the left side of monitor unit. (See Figure B)
Figure A
3. Remove thick clothing from the arm area.
4. Rest for several minutes prior to testing. Sit in a quiet place with your back and arm supported and your feet
uncrossed and flat on the floor. (See Figure C)
5. Apply cuff to your left arm and keep level with your heart. Bottom of cuff should be placed approximately
1-2cm (0.4-0.8'') above elbow joint. (See Figures D&E)
Figure D
6. Press " " Button to start testing.
UNIT OPERATION
Battery Installation
Slide battery cover off as indicated by arrow.
Install 4 new AA alkaline batteries according to polarity.
Close battery cover.
Figure C
28
Figure B
Figure E