Spengler AUTOTENSIO SPG440 Manual página 38

Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
This marking shown on the product indicates that it should not be disposed with other household waste at the
end of its life. To prevent potential harm to the environment or to human health, please separate this product
from other types of wastes and recycle it responsibly. When disposing this type of product, contact the retailer
where product was purchased or contact your local government office for details regarding how this item can
be disposed in an environmentally safe recycling center.
Business users should contact their supplier and check the terms and conditions of the purchasing agreement.
This product should not be mixed with other commercial wastes for disposal. This product is free of hazardous
materials.
WARRANTY
The Blood Pressure Monitor is guaranteed for 2-year from the date of purchase. If the Blood Pressure Monitor
does not function properly due to defective components or poor workmanship, we will repair or replace it freely.
The warranty does not cover damages to your Blood Pressure Monitor due to improper handling. Please contact
local retailer for details.
ELECTROMAGNETIC COMPATIBILITY INFORMATION
The device satisfies the EMC requirements of the international standard IEC 60601-1-2. The requirements are
satisfied under the conditions described in the table below. The device is an electrical medical product and is
subject to special precautionary measures with regard to EMC which must be published in the instructions for
use. Portable and mobile HF communications equipment can affect the device. Use of the unit in conjunction
with non-approved accessories can affect the device negatively and alter the electromagnetic compatibility. The
device should not be used directly adjacent to or between other electrical equipment.
Table 1
Guidance and declaration of manufacturer-electromagnetic emissions
The device is intended for use in the electromagnetic environment specified below.
The customer or the user of the device should assure that it is used in such an environment.
Emissions test
Radiated emission CISPR 11
Conducted emission CISPR 11
Harmonic emissions IEC 61000-3-2
Voltage fluctuations/ flicker emis-
sions IEC 61000-3-3
Table 2
Guidance and declaration of manufacturer-electromagnetic immunity
The device is intended for use in the electromagnetic environment specified below. The customer or the user of
the device should assure that it is used in such an environment.
IMMUNITY test
Electrostatic discharge
(ESD) IEC 61000-4-2
Compliance
Group 1, class B.
Group 1, class B.
Class A
Complies
IEC 60601 Compliance level
test level
± 8 kV ± 8 kV
contact contact
± 2 kV,±4 kV, ± 2 kV,±4 kV,
± 8 kV, ± 8 kV,
± 15 kV air ± 15 kV air
Electromagnetic environment - guidance
The device uses RF energy only for its internal func-
tion. Therefore, its emissions are very low and are not
likely to cause any interference in nearby electronic
equipment.
The device is suitable for use in all establishments,
including domestic establishments and those
directly connected to the public low-voltage power
supply network that supplies buildings used for
domestic purposes.
Electromagnetic environment - guidance
Floors should be wood, concrete or ceramic
tile. If floors are covered with synthetic
material, the relative humidity should be at
least 30 %.
38