Verdemax FE16 Manual De Usuario página 20

Use and Maintenance
• Startup and tips
1. Remove the machine, install the lithium battery, press and hold the power switch for three
seconds, then release it, you will hear a prolonged sound, it means that the scissor is powered
normally.
2. Press the cutting lever continuously and quickly twice, it will automatically open the blade.
3. Before starting work, press the cutting lever to operate the blade empty for a few times and
listen if there is a noise or if the cut is too fast or too slow.
If everything is normal, start working.
4. This pruning shears has an intermediate blade opening adjustment to make smaller branch
cuts. With the scissor on, press and hold the cutting lever for about 3 seconds, you will hear a
sound, immediately release the cutting lever and the blade will position itself at reduced opening.
5. To return to the complete opening of the blade, hold down the cutting lever for about 3 seconds
until you hear a sound, immediately release the cutting lever, the blade will open completely.
6. To stop the blade in the closed position, press and hold the cutting lever until you hear a
sequence of 3 beeps. Release the cutting lever, the scissors will remain closed.
ATTENTION: the scissor is still on.
7. Shutdown: press the power switch for 3 seconds, the green light will turn off.
N.B. if the off switch is activated with the blades open, the scissors will turn off and the blades will
remain open.
Always remove the battery after use.
Keep the tool and the battery out of the reach of children.
Notes: (1). If the scissor is used for a long time, it is a normal phenomenon that it tends to heat up.
You can safely continue to use it.
(2). After the completion of seasonal pruning work, or when replacing the blade, it is
necessary to remove the blade and add lubricating oil between the blades as maintenance.
• Battery charging
The battery of new products is not fully charged. Before charging,
insert the battery into the charger and insert the power plug of
the charger into the power outlet. The "+" of the battery must be
inserted into the "+" of the charger, as shown in the image on the
right. The charger light is displayed in green. After charging,
you can use the battery.
Original instructions
EN
20